Toilet Roll Holder Instructions. To install a toilet paper holder. you’ll need to use the provided template to mark the location of the holder on the wall. Place the completed muzzle on the toilet paper roll. just below the eyes.
Livingshire Toilet Paper Holder Stand Free Standing onbuy.com
• wall anchor (1) is only suitable for use in cavity walls with a tiled surface. Using a 6mm drill bit. drill holes through the marked spots on the template. Ensure that it is level and then mark.
Align and attach template provided to desired fixing location of the toilet roll holder (figure a). Check the roll if it is working;
1.7 some additional tips to follow Place the completed muzzle on the toilet paper roll. just below the eyes.
Delta crestfield toilet paper holder installation instructions Delivery contents / toilet roll holder figure a.
• step 2.offer the back plate up to the wall. Installation instructions and hardware included.
Align and attach template provided to desired fixing location of the toilet roll holder (figure a). Easy to follow instructions and a handy video. find out how to save money by fitting your toilet.
Make the reindeers collar by gluing one to. 3/32 hex key installation warnings figure b.
Here Is A Brief Outline On Mounting An Outboard Motor Correctly.
Rail must be installed to walls that are structurally sound. If installing into a plasterboard cavity wall (untiled) it is recommended that the accessory be attached to the wall in line with a stud or noggin using suitable screws. Using a 6mm drill bit. drill holes through the marked spots on the template.
To Install A Toilet Paper Holder. You’ll Need To Use The Provided Template To Mark The Location Of The Holder On The Wall.
Easy to follow instructions and a handy video. find out how to save money by fitting your toilet. Instructions are provided with the national plumbing code as/nzs 3500.2.2 and local authority requirements which may vary the. • step 2.offer the back plate up to the wall.
Drill 4 holes (2 per bracket) and screw the brackets to the. Installation instructions and hardware included. Make the reindeers collar by gluing one to.
For Installation Of The 1.9261.00. Use The Centre Hole (Figure B) And For Installation Of The 1.9561.00. Use The Three Outer Holes (Figure C).
Take care not to pull the stitches as you turn the holder right sides out pin the top of the roll holder to ensure the lining and the outer fabric align stitch on the edge all around the top of the holder to close the opening. Check the roll if it is working; Finishing the toilet roll holder use the opening to turn the holder right sides out.
3/32 Hex Key Installation Warnings Figure B.
Flow towel ring. toilet roll holder material composition: 8.make sure part is secure before intended function. Test the installation by vigorously pulling on the support handle of the wall toilet roll holder.